Servicing a Shimano Sienna 1000

Features

Propulsion Spool Lip
S Concept: S guard and S arm cam
Graphite Frame
Graphite Sideplate
Graphite Rotor
Aluminum Spool
Varispeed Oscillation
Ported Handle Shank
Super Stopper II
Dyna-Balance
Power Roller II
P3
Approved for use in Saltwater
Rated for use with Mono, Fluorocarbon and PowerPro lines

I opened this reel a few days back just to check if it needs a new lube.  Everything is clean.

Today I have nothing to do, I decided to open it again.

The drag consist of a single metal washer and something like a felt washer.

If you want to change it to carbontex, here is the size 

Shimano Sienna 1000 (1) 19.6mm x 3.2mm x 1mm

Here is the picture of the spool.  Unfortunately, this reel has no extra spool which would have been good.

The plastic rear guard with the screws.

Rotor removed.

This reel has 3 bearings all the same size...13mm x 6.9mm x 4mm.
After cleaning the bearings, i used ardent reel butter as lubricant.

The oscillating slider, drive gear and oscillating gear.  The main gear and the oscillating gear has arrows on them that should be aligned when you reassemble them as failure to do so would result in binding.

The shaft prior to cleaning.

The anti-reverse with instruction that no grease be used in them.

The anti-reverse with the clutch and the washer.

Here is the pinion gear with the bearing.  The bearing has the same size as the bearings in the drive gear.

After a thorough cleanup and lubing...though a few trials on aligning those arrows, the reel is finally cleaned and properly lubed ready to catch more fish.